Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Duct Repair & Sealing for Northgate Homeowners
Leaky ducts waste the air you paid to heat, and in Northgate’s older postwar ramblers and split-levels that leakage often hides behind drywall and above ceilings where nobody looks. If your rooms heat unevenly, your system runs long, or you smell something musty when the furnace kicks on, the ductwork itself may be the problem. Our technicians have up to 9 years of experience with professional-grade tools, and we offer same-day scheduling when the day allows. We don’t just clean – we seal, repair, and sanitize, so a dirty system doesn’t get recontaminated the week after we leave. Call (877) 492-3448 and we’ll set up a free estimate.
What Our Duct Repair & Sealing Service Includes
Ductwork in this part of Washington takes a beating from wet winters, temperature swings, and decades of settling. Repair isn’t one job – it’s a set of fixes matched to what the inspection actually finds. Here’s what each piece covers and when it matters.
Duct Sealing
Duct sealing closes the gaps at joints, seams, and connections that let conditioned air escape into crawlspaces and attics. You need it when rooms never quite heat up, when the system seems to run constantly, or when a pressure test shows more leakage than it should. We seal those leaks with mastic and approved tape rated for ductwork, then confirm the improvement before we call the job done.

Flex Duct Repair
Flex duct is the corrugated, insulated run you’ll find feeding registers in many Northgate homes. It needs repair when it’s crushed, kinked, torn, or sagging between supports, all of which choke airflow to the room it serves. We straighten routing, replace damaged sections, and re-support runs so air actually reaches the far bedrooms instead of stalling halfway.

Metal Duct Repair
Sheet metal trunks and plenums develop separated seams, loose hangers, and pinholes over time, and those small failures add up fast. You need metal repair when you hear rattling, see condensation, or find dust streaks near a joint. We reseal seams, reattach or replace failed sections, and address the vibration that loosens fittings in the first place.

Duct Insulation
Duct insulation keeps the conditioned air at the temperature it left the equipment with, and in a damp climate it also controls condensation on cold metal. It’s needed when runs in the attic or crawlspace are bare, sagging, or waterlogged from a past leak. We replace failed insulation with duct-rated wrap so the air arriving at your register is the air you paid for.
Mastic Sealant
Mastic is the brush-on sealant we use on permanent joints, and it outlasts the fabric tapes that fail on ductwork within a few seasons. You need it wherever seams, boots, and plenum connections are leaking or where old tape has dried out and peeled. We apply mastic to the joints that need a long-term seal, giving the system a fixed closure rather than a temporary patch.
Air Leak Repair
Air leak repair is the hunt for the gaps at boots, registers, and wall penetrations where air escapes into the structure instead of the room. It’s needed when you feel drafts at the register, notice dusty streaks on the wall, or find a room starved for airflow. We locate leaks with a pressure check and seal them one by one, then retest to confirm the fix held.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Brands We Service for Duct Repair & Sealing
We work with Honeywell and Aprilaaire air quality equipment alongside the duct system itself, which matters because the ductwork and the air treatment have to agree with each other. When we inspect the system, we can also assess whether a whole-home filter or humidifier is a fit, and we know where those components tend to wear out. The leak in the duct doesn’t get fixed by a filter, but the two work in the same system, and we look at both.
On the cleaning side we use Rotobrush mechanical agitation and Nikro negative-air extraction, and for heavier contamination jobs we bring Abatement Technologies equipment to the work. Those are professional-grade tools, not shop vacuums and brushes, and they let us handle mold, heavy particulate, and remediation-level conditions that a basic cleaner has to turn away. Whether you have Honeywell, Aprilaire, or any other make, we can help.
Signs You Need Duct Repair & Sealing Right Now
These are the symptoms that usually mean the ductwork is leaking, torn, or underperforming. Any one of them is worth an inspection.
- Rooms that never reach the thermostat setting. A bedroom that runs cold while the living room swelters often points to a crushed or disconnected run feeding that room. That’s a leak or a restriction, not a furnace problem, and sealing it usually restores the airflow.
- Musty or dusty odors when the system starts. If the smell arrives the moment the blower engages, the system is drawing air through crawlspace, attic, or wall cavities and pushing it into your rooms. Sealing the leaks stops that path at the source.
- Dust streaks on walls or ceiling near registers. Those dark trails are air escaping at the boot or register connection, and the dust in your home is the trail it leaves. It’s a clear sign of an air leak that a simple register reset won’t fix.
- Higher bills without a change in use. A system with significant leakage runs longer to hit the same temperature, and the extra runtime shows up on the bill before it shows up anywhere else. Duct sealing closes the gap that’s costing you.
- Visible damage in the attic or crawlspace. Crushed flex, torn insulation, or disconnected sections are common after remodel work, pest activity, or years of settling. If you can see the damage, the system is likely losing air right there.
Our Duct Repair & Sealing Process – Step by Step
We keep the work transparent because you should know what got found and what got fixed before you pay for it. Here’s how a job typically runs.
- 1
Inspection. We walk the full system, including attic and crawlspace runs, and document what we find with photos. That gives us a working picture of where the leaks are and how bad the damage runs.
- 2
Diagnostic pressure check. We use a pressure test to measure how much air the system is losing and where it’s going. It turns “seems drafty” into a number we can compare against after the repair.
- 3
Scope and estimate. We give you one flat price for the job, in writing, before any work begins. No per-vent pricing and no surprise line items later in the visit.
- 4
Repair and seal. We repair damaged sections, reseal joints with mastic, replace failed insulation, and address the boots and connections one by one. The goal is a closed system, not a patched one.
- 5
Retest and report. We run the pressure check again and show you before-and-after photos of your own ductwork so you can see exactly what changed.
Before any of that, we clean. A dirty system with leaky ductwork just recontaminates as soon as someone turns the blower on, which is why duct repair & sealing belongs with the cleaning rather than after it. If you’ve been putting off a pass through the air duct cleaning Northgate service, this is the moment to pair the two.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Northgate?
Duct repair and sealing in Northgate typically runs $350 to $900 for a standard job, and a whole-system sealing project with insulation replacement can land between $1,200 and $2,500 depending on how much ductwork is in a crawlspace or attic and how bad the damage is. The written estimate sets the final price. We don’t quote a teaser figure and then add line items once the technician is on site.
What drives the price is the amount of ductwork, whether the runs are in a tight crawlspace or a roomy attic, how many joints need mastic, and how many sections of flex or metal have to be replaced outright. Insulation replacement adds cost because it’s a separate material. Keeping the duct clean alongside the repair helps too, since a sealed system that starts clean stays clean longer.
A free estimate should cover the inspection, the pressure readings, the scoped repairs, and the price. Ask whether the seal is being applied with mastic or with tape, and whether you’ll get photos of the work. Those are the two questions that separate a real repair from a walkthrough with a tube of tape.
Where the repair is a bigger job, we bring the same equipment we use for contamination work so the ductwork is clean before the leaks are closed. Either way, the work is one visit for the whole system when the scope allows it, and duct repair & sealing in this part of King County has a real role in getting the system back to where it should be.
Duct Repair & Sealing Near Northgate – Our Service Area
We serve homeowners across Northgate and the surrounding neighborhoods, including Lake City, Ravenna, Wedgwood, View Ridge, Maple Leaf, Bitter Lake, Green Lake, Lake Forest Park, Kenmore, Shoreline, and Fremont. Scheduling is handled Sunday through Friday, 7am to 7pm, and the estimate is free. Call (877) 492-3448 and we’ll book you in.
Serving Northgate, WA – Our Local Coverage Area
We serve Northgate and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Duct Repair & Sealing in Northgate
Duct repair and sealing is the work of fixing damaged ductwork and closing the leaks that let conditioned air escape before it reaches your rooms. It covers flex duct repair, metal duct repair, insulation replacement, and sealing joints with mastic or approved tape. It’s separate from cleaning, but the two are usually done together because a leaky system gets dirty again quickly. Call (877) 492-3448 and we’ll walk you through it.
Most jobs run a few hours to a full day, depending on how much ductwork there is and how many runs need replacement. A single room’s flex duct fix is quick; a whole-system sealing with attic and crawlspace work takes longer. We’ll tell you the expected window before we start, and the estimate reflects the scope. Call (877) 492-3448 to schedule.
Typical jobs run $350 to $900 for standard repair, and larger projects with insulation replacement can reach $1,200 to $2,500. The number depends on the extent of the damage, the layout of the runs, and the materials needed. The written estimate sets the final price, and estimates are free. Call (877) 492-3448 for an exact quote.
Yes, we work with Honeywell and Aprilaire air quality equipment alongside the ductwork itself. We can assess whether a whole-home filter or humidifier needs attention while we’re sealing the ducts, since the two systems interact. If something in that equipment is failing, we’ll tell you what we see. Call (877) 492-3448 to set up an inspection.
Same-day scheduling is available when the day allows, and we run a free estimate before any work starts. We answer 24/7, and fast dispatch is available 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (877) 492-3448 to get on the schedule.
We stand behind our work, and the arrangement is explained in the written estimate before the job begins. What’s covered depends on the materials and the scope, and we’ll go over it with you in plain terms. If you have questions before you commit, ask during the estimate. Call (877) 492-3448 to book one.
Clear access to the registers and to the attic or crawlspace hatch, and move anything breakable out of the work area. If pets are in the home, secure them in a room where we won’t be working. Wear old clothes if you plan to walk through the crawlspace with the technician, and the before-and-after photos save you that trip. Call (877) 492-3448 if you’re unsure what to clear.
Schedule Your Duct Repair & Sealing Service in Northgate Today
Ductwork that’s leaking or damaged costs you on every heating and cooling cycle, and the fix is usually a single visit. We give you one flat price per system, agreed before work starts, with before-and-after photos of your own ducts. Call (877) 492-3448 for a free, no-obligation estimate. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday. Let’s get the system closed up and running the way it should.
Written by the team at Air Duct Cleaning Northgate.