Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Air Quality & Sanitizing Cost in Northgate?
Air quality and sanitizing in Northgate typically costs $450 to $1,900, with most single-system homes landing between $650 and $1,100 for a full clean-and-treat package. Ductwork sanitizing alone (no cleaning first) usually runs $300 to $600. Whole-home systems with multiple returns, added filtration, or contamination-level problems climb toward $1,900 and above.
The final number depends on system size, how much contamination we find during inspection, and whether you want filtration hardware added. We set the price per job from a free written estimate, so you know the total before any work starts. Call (877) 492-3448 to book one. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday.
Key Takeaways
- Ductwork sanitizing on its own: $300 to $600 for a typical Northgate home.
- Clean, seal, and sanitize as a package: $650 to $1,100 most often.
- Mold, heavy particulate, or remediation-grade contamination: $1,200 to $1,900+.
- Sanitizing works best after mechanical cleaning, not instead of it.
- Every job starts with a free written estimate and a fixed price.
Air Quality & Sanitizing Cost Breakdown (2026)
The table below shows what each piece of an air quality and sanitizing visit typically costs in Northgate. Most homes combine two or three of these into one appointment.
| Service item | Typical Northgate range |
|---|---|
| Full inspection and airflow assessment | $0 with a booked cleaning (standalone $95 to $150) |
| Ductwork sanitizing (fogging, per system) | $300 to $600 |
| Air handler and coil sanitizing | $150 to $350 |
| Mechanical duct cleaning with negative-air extraction (prerequisite for best results) | $400 to $800 |
| Duct repair and sealing (per leak, or by linear foot of run) | $250 to $750 |
| Whole-home media or HEPA filtration add-on (Honeywell, Aprilaire) | $400 to $1,200 installed |
| Remediation-grade treatment for mold or heavy contamination | $1,200 to $1,900+ |
| Dryer vent cleaning (often bundled into the same visit) | $120 to $250 |
What pushes a Northgate quote up: the number of returns and registers, a finished basement or converted attic that adds square footage to the system, visible microbial growth on duct liner or the air handler, and whether filtration hardware is being added. What pulls it down: a single-system home with accessible trunk lines, sanitizing done right after a cleaning (no second visit), and combining services so the inspection and setup are only done once.
One thing worth understanding before you compare quotes: sanitizing is a treatment, not a clean. Fogging a dirty duct seals contamination in place rather than removing it. That’s why we pair sanitizing with the full two-method cleaning our team runs, using Rotobrush mechanical agitation to break material loose and Nikro negative-air extraction to pull it out of the system. See the Air Duct Cleaning Northgate process for how that works on a typical home.
What Affects Air Quality & Sanitizing Pricing in Northgate
- System size and layout. A small single-story home with one return is a very different job from a two-story with multiple zones. More branch runs mean more surface area to treat, and that’s the single biggest driver of the number on your estimate.
- Level of contamination. Light dust and odors sit at the low end. Visible mold growth, rodent activity, or years of built-up particulate push the job into remediation-grade territory, where we bring in Abatement Technologies equipment to handle the load.
- The moisture story in Northgate. This part of the Seattle area sees long stretches of cool, damp weather from fall through spring. Homes here run closed up for months, and that trapped humidity feeds microbial growth on duct liner and coil surfaces far more than a dry climate would. Sanitizing in Northgate often means addressing moisture, not just dust.
- Whether sealing is needed. Leaky ducts pull attic and crawlspace air back into the system, which undoes a sanitizing job within a season. Duct repair and sealing handled in the same visit keeps the treatment working. It adds cost up front and saves you from repeating the job.
- Filtration upgrades. If your system can take a media cabinet or a higher-MERV filter setup, we can advise on Honeywell and Aprilaire options during the same visit. The hardware is a separate line item from the treatment itself.
- Access. Ducts buried behind finished ceilings, tight crawlspaces, or an air handler tucked into a closet all add labor. We look at access during the free inspection so nothing surprises you later.
Northgate’s housing stock matters here too. The neighborhood has a mix of mid-century homes and newer townhome and apartment construction near the transit hub and the mall. Older homes often have duct systems that were added or modified well after the house was built, so we frequently find disconnected runs, undersized returns, and gaps at the plenum. Newer construction tends to have tighter ductwork but less filtration than you’d expect. Both situations affect what a sanitizing quote looks like.
Is sanitizing worth the cost if my ducts are already clean?
Yes, when there’s a specific reason: musty odor that returns after cleaning, a recent water intrusion, mold found during inspection, or a household member with respiratory sensitivity. Sanitizing a genuinely clean system with no odor or moisture problem usually isn’t money well spent. We’ll tell you if it isn’t. The honest answer on a clean, dry, well-sealed system is to put the budget toward filtration or sealing instead.
Our air quality & sanitizing service exists as a standalone treatment precisely because the air in the system is a separate concern from the duct surfaces. If you’ve had a cleaning done elsewhere and the smell came back, that’s a sign the source wasn’t addressed, not that you need the same job twice.
How does the cost compare between sanitizing alone and a full clean-and-treat?
Sanitizing alone runs $300 to $600. A full clean-and-treat package typically runs $650 to $1,100. The package costs more, but it delivers a result that lasts because the contamination is physically removed before treatment, and the treatment reaches surfaces that are actually clean.
Think of it this way. A fogging treatment applied to a dirty system treats the top layer of dust and leaves the rest. A package does the mechanical work first: Rotobrush agitation through the runs, Nikro negative-air extraction holding the system under vacuum so loosened material leaves the house instead of settling in your living room. Then sanitizing reaches bare duct surface and the coil. In practice, a full package in a Northgate home is roughly 40% to 60% more than sanitizing alone, and it’s the version that holds up through a wet Northwest winter.
What does mold remediation in ductwork cost in Northgate?
Remediation-grade air quality work in Northgate typically falls in the $1,200 to $1,900 range, and higher on large or heavily affected systems. This covers containment, source correction, mechanical cleaning of affected surfaces, antimicrobial treatment, and verification that the system is dry and sealed.
Mold in a duct system is almost never just a duct problem. It points to a moisture source: a coil that isn’t draining, a humidifier running in a sealed house, condensation on cold duct runs in a vented crawlspace, or a roof or plumbing leak above the system. Anyone who quotes a fogging treatment without finding and fixing that source is selling you a repeat job. Our team carries Abatement Technologies equipment specifically because these situations need more than a shop vac and good intentions. If remediation is beyond what a duct cleaning can honestly solve, we’ll say so and point you to the right trade.
Because these jobs involve contaminated air and, in some cases, biological growth, we don’t recommend opening the system yourself to inspect. A trained technician with proper containment and protective equipment should look at it.
How to Save on Air Quality & Sanitizing in Northgate
- Combine everything into one visit. Cleaning, sealing, and sanitizing on the same appointment means one setup, one inspection, one trip. That reduces labor on your invoice compared with booking them separately.
- Fix leaks before you sanitize. If ducts are leaking into the attic or crawlspace, sanitizing is wasted money. Sealing first keeps the treatment inside the system where it belongs.
- Ask whether all runs need treatment. Sometimes only the affected zones need fogging. A good technician will scope the system and tell you which runs are actually the problem.
- Handle the moisture source. Running your bath fans longer, fixing a dripping coil, and keeping indoor humidity in check costs little and prevents the mold regrowth that leads to another remediation bill.
- Get the estimate in writing before any work begins. Free estimates are the norm here, and a fixed written price is the best protection against add-ons. Call (877) 492-3448 to schedule yours.
- Bundle dryer vent cleaning while we’re there. If it’s been a few years, having the vent cleaned during the same visit costs less than booking a separate trip, and it’s a genuine safety item.
One caution on price shopping: a very low quote often reflects a blow-and-go clean with no negative-air extraction and no inspection. What you save up front gets spent again on the second visit when the contamination returns. The equipment matters more than the coupon.
FAQs – Air Quality & Sanitizing Cost
How much does air quality and sanitizing cost in Northgate?
Most Northgate air quality and sanitizing jobs run $450 to $1,900, with a typical clean-and-treat package at $650 to $1,100 and standalone ductwork sanitizing at $300 to $600. Remediation-grade work for mold or heavy contamination goes higher. Call (877) 492-3448 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Can you sanitize my ducts the same day?
Same-day service is often possible, and a standard sanitizing treatment usually takes two to four hours. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (877) 492-3448 to check availability.
Is sanitizing cheaper than a full duct cleaning?
Yes. Sanitizing alone runs $300 to $600 against $650 to $1,100 for a full clean-and-treat package. But sanitizing a dirty system delivers a short-lived result, so if your ducts haven’t been serviced in years, the package is the better value. Call (877) 492-3448 and we’ll tell you which one your home actually needs.
How long does a sanitizing treatment last?
A properly applied treatment on a clean, dry, sealed system typically holds for one to three years. It lasts a matter of weeks if the ducts leak or a moisture source is still active. That’s why we look at sealing and moisture during any HVAC cleaning visit. Call (877) 492-3448 for an honest read on your system.
Can you sanitize without cleaning the ducts first?
We can, and it costs $300 to $600, but we’ll always explain the tradeoff. Treating a dirty system kills surface microbes and leaves the contamination underneath. On a system with visible buildup, cleaning first is the only approach that gets a lasting result. Call (877) 492-3448 to book a free estimate and inspection.
Related Services and Nearby Areas
Air quality and sanitizing is one of five services we run, alongside air duct cleaning, dryer vent cleaning, HVAC cleaning, and duct repair & sealing. If you’re outside Northgate, we also take calls from homeowners in Seattle, Shoreline, Lake City, Ravenna, Maple Leaf, Pinehurst, and Bitter Lake. If you’re comparing options and want background first, our air duct cleaning cost guide explains the numbers across all five services.
Get a Free Written Estimate in Northgate
Pricing for air quality and sanitizing is set per job from a free written estimate, so the number we give you is the number you pay. Our technicians have up to 9 years of experience, use professional-grade equipment from Rotobrush, Nikro, and Abatement Technologies, and can advise on Honeywell and Aprilaire filtration upgrades if your system could use one. One visit can cover cleaning, sealing, sanitizing, and dryer vent work together. Call (877) 492-3448 for your free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Your ducts work harder than you think. A Northgate home running closed up through a wet winter asks a lot of them, and this is the season to check.
Pricing reflects the Northgate market as of 2026. Air Duct Cleaning Northgate offers free estimates – call (877) 492-3448.
Written by the team at Air Duct Cleaning Northgate.
What Our Customers Say
"They photographed every return and supply before starting and sent me the file afterward. No upsell to a sanitizing treatment I didn't need."
- Shannon Sutton"My wife's allergies had been bad in this house since we moved in. It's been two months since they did the ducts and it's noticeably better. Not a miracle, but real."
- Dev Shah"Ran a negative air machine on the whole system rather than the shop vac on a stick that the cheap outfit down the road uses. Showed me the before and after photos from inside the trunk line and it was genuinely disgusting."
- Sanjay Sharma